Be sure the hood is fully latched before driving your vehicle. Entries are updated each time that the phone is connected. Avoid ice or slippery areas. Replace the Sealant Bottle 1 and Sealant Hose 6 4. Power Distribution Center Fuses 8.
Pass the tether strap hook under the head restraint behind the child seat, though the tether strap loop behind the seat and over to the right or left outboard tether strap loop. They contain carbon controls to force outside air into the vehicle. Never drive with your parking brake engaged. As with all vehicles, tended is dangerous for a number of reasons. I would start by put a Multimeter on the battery while it's off should be no less than 11. This means the seat belt is 1. Vehicle Security Warning: If your vehicle security alarm is equipped, a red dot will flash when the alarm is triggered.
Press the odometer reset button to turn the message off. We're all familiar with that particular groan we let out when we're driving along as usual and one of our vehicle dashboard lights comes on. Jump-starting can be dangerous if done improperly so please follow the procedures in this section carefully. Tire Pressure Monitoring System Warning: If the pressure is too low in at least one of your , an exclamation point lights up inside the outline of a tire. I have contacted the dealer to ask them if they would help honor what is in fact a vehicle with just 1000 miles more than the 36,000 mile warranty and they refused to take any responsibility for the failure of the abs system or the blown caliper and rotor.
The volume can be set between 0 and 30. The alternator is original I have about 90 thousand miles. ® Once you have downloaded the App, you may start your vehicle or lock it from virtually any distance. This may be accomplished using a tow dolly or vehicle trailer. If you lift the black thing up and remove the fuse you will notice it is blown. To avoid the risk of forcing the vehicle off the jack, do not tighten the lug nuts fully until the vehicle has been lowered.
Do not spray cleaner Do not bleach, dye, or clean the belts with chemical directly on the mirror. To see the 12 preset stations per band, press the arrow button on the touchscreen at the top right of the screen to toggle between the two sets of six presets. Must meet 3 micron ® rating. The lockup could only be remedied by pulling to the side of the road, shutting down and then restarting the engine - tantamount to rebooting a computer. This means that your which you can use prior to going to the test station. Route the tether straps following the directions for right and left seating positions, above. Oil Pressure Warning Light The tachometer indicates engine speed in Revolutions This light indicates low engine oil pressure.
Engine Coolant Pressure Cap 9. Always buckle your belt into the buckle nearest you. Pass the tether strap hook under the head restraint behind the child seat, though the tether strap loop behind the seat and over to the right or left outboard tether strap loop. Therefore, only keys that are pro- Insert the key in the ignition switch and start the engine. Use snow tires only Run Flat tires allow you the capability to drive 50 miles in sets of four;. Attach the hook to the center tether strap loop see diagram.
The drivers preferred units can be selected through the instrument panel settings if equipped. Navigation is optional on the Uconnect 8. Adjust the settings with the + and — or will recall whether it was on or off at last ignition off. Always Pedals that cannot move freely can cause loss of properly reinstall and secure floor mats that have vehicle control and increase the risk of serious per- been removed for cleaning. Lift the spare tire with one hand to give clearance to from the wheel.
Once this report has been filed, Uconnect care can help locate your vehicle. Turn on the Hazard Warning flasher. This card is required as proof of Action Display ownership if the radio is stolen or when seeking assis- When you turn the radio on, the dis-. Pressing the Up or Down Arrow soft-keys check-mark appears next to the setting, showing that on the right side of the screen will allow you to toggle up setting has been selected. It will be the fuse on the bottom and toward the front of the panel with a black cover over it. Turn on the Hazard Warning flasher.