To remove the spare tire, find and remove the bolt cover, then use your lug nut wrench to loosen the bolt holding the tire. If the spare tire does not lower to the ground, the secondary latch is engaged causing the tire not to lower. Loosen the cable by rotating the hoist shaft counterclockwise 3 or 4 turns. Push the tire onto the hub. They can be as silly as turning off and on the headlights 3 times or honking the horn with the key turned to the on position. Turn the wrench counterclockwise until tire is lowered to the ground and the cable is slightly slack. Make sure you are in a safe area that is level and free of traffic before attempting to fix a flat tire.
The crank handle goes into the hole just above the bumper in the centre of the rear bumper, then wind down the chain and support to release the spare wheel. Insert the lug nut wrench on the hex nut in cargo floor. The bolt is located in a recessed area that is protected by a small square plastic covering. Remove the spare tire fastener's plastic cover, place the lug nut wrench onto the lug nut holding the tire onto the bolt, turn the wrench in a counter-clockwise direction until the tire is released and reaches the ground. Screw the lug nuts onto the tire. Remove the retainer from the spare tire.
Lift the 3rd row seat cushion. Once you own an automobile, getting a flat tire is inevitable. Position the center of the transmission jack under the secondary latch release button at the center of the spare tire. The best way to avoid injury is to never get under your vehicle while it is jacked up. Continue to rotate the shaft until the spare tire can be pulled out from under the vehicle and removed. If the spare tire is hanging by the cable, rotate the hoist shaft counterclockwise until the tire is low enough to remove.
Place a transmission jack, or equivalent, under the spare tire. This video shows you where the spare tire, jack and jack kit is located in your Rondo how to assemble the components of the jack kit, how to replace the flat tire for your spare tire and safety precautions to take when using your jack. Raise and support the vehicle. Most Kia jack kits include the jack, a jack handle and a lug nut wrench. . Tighten the lug nuts just enough so that the tire will not fall off when the vehicle is lowered.
Arrange the arms of the transmission jack so they will support the tire after it has been released. Removing the spare tire 1. If the spare tire cannot be lowered, rotate the hoist shaft counterclockwise until approximately 15 cm 6 in of cable is exposed. Learning how to change a tire is essential for every vehicle owner. Open the liftgate, locate the U-shaped slits in the carpet, and flip up the piece of carpet to expose the hex nut. If the spare tire can be lowered, repeat steps 1 and 2 to see if the spare tire can be removed.
Raise the jack until the spare tire stops moving upward and is firmly held in place, releasing the secondary latch. If you can't find it in there the dealer will have a tool to reset it for you. Tighten the cable by rotating the hoist shaft clockwise until you hear 2 clicks or feel it skip twice. While following the instructions provided in your Rondo's owners manual and in this video will help minimize the risk of injury. Feb 23, 2012 Hi, the spare tire is stored on the underside of the vehicle, under the right-side cargo door. Remember also, that even if your car is jacked up properly, another car could hit it and knock it over; therefore, be sure to give careful consideration to your environment before raising your car. It is possible to get a flat tire anywhere and at any time, so knowing how to change a tire is good information to have.
The video above shows you how to change a flat tire in your 2007 Kia Rondo. Line up the holes of the new tire with the wheel studs of the hub. You cannot overtighten the cable. The crank handle goes into the hole just above the bumper in the centre of the rear bumper, then wind down the chain and support to release the spare wheel. Feb 28, 2010 The spare tyre is on a cradle under the rear of the car.
Remove the jack assembly from the bag under the seat. . . . .