Differential fluid is pretty thick and tends to smell like rotten eggs, so working with a clean area and helps. Recommended oil for my 2008 Tundra Product Name Product Description Capacities Product Signature Series 5W-30 Synthetic Motor Oil - Awesome cleaning power unmatched by other synthetic oil brands! Place your drain pan underneath the transmission fluid pan and remove the 14mm drain plug. I have done these services before without complaints. Then remove the 4 screws that hold in the oil filter. Once your back to P, set the e-brake and leave your engine running. Also note there may be instructions for determining the level if… In between the engine and exhaust system you can find a dipstick usually it has an yellow handle. Then click Checkout after you have added the last item to the cart.
Squeeze the sides of the box inward a little and pull it out. So far, the only thing slightly worrying me is when i start the truck and shift from park to reverse, it like powers into gear. And the fill is in the same place as the dip stick. The smaller of the two new O-rings replaces the existing O-ring on the screw. Open it and pull out the cabin air filter and replace it.
It is jam packed with extra engine protection, which allows you to go up to 12,000-miles or one year, whichever comes first, between oil changes! Talk to a Toyota service manager if you don't believe me. I could be wrong but if you take it to the dealer for the trans service don't they flush the system. This image has been resized. You can bring the used oil to a local auto parts store for recycling. I went by this procedure, even though the write up is for a 2nd gen, it's very similar on a 1st gen. Talk to a Toyota service manager if you don't believe me. If you are wondering about how much oil capacity your engine will hold then it is listed on this page for your convenience.
Take out your truck for a drive to get the oil up to temperature and check for leaks. And if that is the case then the part number for Snapon is 09228-06501. I think I might have used Mobil 1 last time, it was just what was available at the time. Tighten everything back up drive for 5 to 10 miles confirm no leaks. I used to do all my own maintenance on my vehicles. The vehicle must be level and the fluid thoroughly warm when you check.
To completely remove the skid plate, three small screws holding it to the front plastic bumper skirt must also be removed. Something else that I decided to let Toyota do. No matter the situation, Advance Auto Parts has the Automatic Transmission Fluid product you desperately need. They told me that the 5. This was great as I was kind of worried that a mechanic would not do it. The cartridge-type oil filter is in the housing.
I'll bet you can't find the transmission dip stick either. Click this bar to view the full image. So I've decided to let Toyota do the oil changes. Again pull the stick out and check the fluid level on it. Since you're asking about transmission 'fluid' rather than lubricant I'll guess you're asking about an automatic transmission.
Pull the dipstick its near the battery and check the level. This image has been resized. Believe me it not as easy as you think. All the answers to your maintenance questions are in there. Something else that I decided to let Toyota do. Do your self a favor go to a Toyota dealer and let them do it.
Plus save time and money since you will not be visiting those quick change places so often! Something else new to confuse you. You have to drop the skidplate first. I think you may want to read the following before you try to drain the oil on your 2008 Tundra if you have a 5. This link also has a vintage vehicle lookup, along with a power sports oil and filter guide. You can also buy and and pump the oil in.