After removing the two bolts you will be able to pull the starter out of the housin … g area and disconnect the wires on the solenoid. Remove the terminal nut and separate the battery starter cable from the starter motor. Oversize fees also waived on this item. But if you have 17 inch original wheels and you want to buy aftermarket wheels for your truck they wont work. Chock the wheels to be sure vehicle will not roll. Ã To disconnect the hard-shell connector from the solenoid S terminal, grasp the plastic shell and pull off; do not pull on the wire. Pull straight off to prevent damage to the connector and S terminal.
Pull the drive shaft toward the rear of the vehicle until the front of the drive shaft pulls out of the transmission. If it is idling rough there is probably a larger problem in play. Start the engine several times to check starter motor operation Note: Disconnect both batteries if the truck has more then one. Tighten the terminal nuts to 79 inch lbs. It is bolted to the bell housing of the transmission. Install the starter solenoid safety cap. Open to residents of the U.
Assemply is reverse of removal with special attention to aligning marks on the drive shaft to the mark on the differential. Underneath the passenger side of the truck you will find the starter. Vehicle Photography Not Available We're sorry. Place a pan under the transmission-end of drive shaft and have clean rags handy. Valid on orders shipped in the contiguous United States.
There is a special tool which should be located with your tire changing tools, once you have this tool you insert it into the small hole next to the rear licence plate, you then turn the handle Counter clockwise I think and the spare tire will be lowered to the ground. Visit for complete rebate details and redemption information. Its held in place by a this … steel cable good luck. Remove 4 bolts from differential-end of drive shaft. Applicable shipping fees will be charged, if required, on additional items added to the order. Summit Bucks are redeemable via phone, mail, online or by presenting them at a retail location. Disconnect the solenoid S terminal connector, if equipped with a starter mounted solenoid.
It will take a 13mm socket and extension. Connect the solenoid S terminal connector, if equipped with a starter mounted solenoid. Install the battery starter cable and a terminal nut to the starter motor. Disconnect the negative battery cable. Tighten the bolts to 15-20 ft.
Connect the negative battery cable. Place the starter motor in position and install the starter motor retaining bolts. A high quality photo of your vehicle is not available in our library of images. . Remove the starter motor retaining bolts. We photograph vehicles as they become available to us in our area, but some older or hard-to-find models may not be represented within this tool on our site due to availability. Allow 6-8 weeks after Sponsor receives the request for processing.
Disconnect the positive post of the battery cable. Push the drive shaft slightly toward the front o … f the vehicle while pulling downward on the drive shaft and lower it to the ground. Mark the differential and drive shaft before removing drive shaft. A 1999 will be computer controlled and you cannot adjust the idle like you would with a carb. Remove the starter terminal cover. Remove the starter motor from the vehicle.
Most auto parts stores will read the trouble codes from the computer for you and help you track down the problem. Raise and safely support the vehicle. . . . . .